Brochure

31
Mxx xx°
31
Application
plug & play in outdoor applications
Electrical installations using the ”Lego principle“
Outdoor lightingOutdoor lighting
■ The challenge:
Expert operation plays a major role
particularly for electrical installations
outdoors.
Difficult installation conditions and high
time pressure often cause errors, loss of
the protection degree and finally failure
of the system.
Unfortunately customers often send
their complaints about such cases to
the luminaire manufacturer and are left
with a bad impression.
■ The solution:
As a complete installation system,
gesis
IP+ is optimally adapted to these
increased requirements. It is very
flexible in its application and has proven
technology at its disposal. Luminaires
can thus be delivered in a pre-
assembled design. They only have to be
plugged in on site. The connectors are
also touch-safe when they have not yet
been plugged in; they provide a locking
device against accidental loosening.
The possibility of connecting almost
all customary cable types (also
underground cables), as well as the
IP 68 protection degree make the RST
connector a strong partner for outdoor
lighting.
Also see:
RST 20i2 Protection class II,
low voltage
RST 20i3 Power 3 pole
RST 20i5 Power 5 pole
Connectors:
For the various luminaire types,
power connectors for 250 V and
low-voltage connectors for LED
technology up to 50 V are available.
These are mechanically coded and
can therefore not be mismated.
For parallel applications, this provides
additional safety.
It is not possible to lay the components
directly in the ground. In order to satisfy
VDE 0100-520 the connections must
be protected mechanically in addition
and must be accessible for inspection,
testing and maintenance.