User guide

WMOD SERIES ENCLOSURES
NEMA 12 MODULAR FREESTANDING DISCONNECT
www.hubbell-wiegmann.com
Data Subject To Change Without Notice
CATALOG NUMBER BODY/DOOR STEEL GAUGE SIZEHXD(SEE DRAWING BELOW)
WMOD7218EPT Formed end plate with gasket and bolts 72.13x18.13 (1832x460)
WMOD7218FTPT Flat end plate with gasket and bolts 72.00x18.50 (1829x470)
WMOD7218GK Gasket kit with gasket and bolts 72.00x18.00 (1829x457)
WMOD8418EPT Formed end plate with gasket and bolts 84.13x18.13 (2137x460)
WMOD8424EPT Formed end plate with gasket and bolts 84.13x24.13 (2137x613)
WMOD8418FTPT Flat end plate with gasket and bolts 84.00x18.50 (2134x470)
WMOD8424FTPT Flat end plate with gasket and bolts 84.00x24.50 (2134x622)
WMOD8418GK Gasket kit with gasket and bolts 84.00x18.00 (2134x457)
WMOD8424GK Gasket kit with gasket and bolts 84.00x24.00 (2134x610)
ACCESSORIES FOR MODULAR WMOD SERIES NEMA 12 FLANGE-MOUNTED DISCONNECTS
GASKETGASKET
0.75
2.63
HHH
Gasket KitFlat End PlateFlanged End Plate
D
DD
F43
Space Occupied by Disconnect
Note:
1. See pages F51-F60 for various brands of disconnects for “E”, “F”, “G” and
“WB” dimensions.
2. Disconnects will occupy space on panel shown by dimensions “E”, “F” and “G”. Wiring
space “WB” is available when disconnect is installed in the enclosure.
3. When ordering 24.13 (613mm) deep enclosures, long connecting rods must be
ordered. Long connecting rods are available from disconnect manufacturers.
• ABB Controls flange-operated devices
• Eaton Cutler-Hammer C361 devices
• Eaton Cutler-Hammer C371 operating mechanisms C371E and C371F, order
catalog number C371CS1 connecting rod. Fo r C37 1G an d C371K, order cata-
log number C371CS2 connecting rod.
• General Electr ic TDA devices, order catalog number TDSR extended length
drive rod
• For Schneider Square D
®
9422 devices, order catalog number 9422-R2 extra
long operating rod(s). Some devices require two rods.
Refer to National Electrical Code
®
article 430-10(b) for wiring space required for line
side conductors to be connected to disconnect. Verify your application
to determine if wiring space is adequate.
PANEL
TOP HOLE IN
DISCONNECT
HANDLE
TOP OF DISCONNECT
THIS SPACE IS OCCUPIED
BY DISCONNECT SWITCH
AND FUSE CLIP (IF USED)
OR CIRCUIT BREAKER.
4.06
2.75G
WB
F
E
C
WBWB
L
End Plates
Used to seal open end(s) of an assembly of modu-
lar enclosures. End plates are available
in two types:
• The 2.63" thick End Plates allow extra wiring
space. The end plate includes a gasket and
mounting bolts.
• The Flat End Plate provides a low profile
cover for the open end of a modular enclosure.
The flat end plate includes gasket and mounting
bolts.
Gasket Kit
Used to join modular enclosures together, includes
gasket and mounting hardware.