User`s manual

CRU-WiebeTech
R T X 4 0 0 - Q R U s e r ’ s M a n u a l - 6 -
4. RAID Configuration (Skip ahead if you purchased a pre-configured unit.)
To set up your RAID you’ll need to use WiebeTech Configurator 2.0. If you have not already installed
WiebeTech Configurator 2.0 then follow the steps below. If it is installed on your computer then skip
below to section 4.1.2.
4.1 WiebeTech Configurator 2.0
4.1.1 Installing WiebeTech Configurator 2.0
Configurator 2.0 can be found on our webpage (
http://www.wiebetech.com/software/configurator.php) or
on the WiebeTech Product CD in the WiebeTech Extras folder.
• To install from the web, go to the webpage and select the Configurator that’s compatible with your Mac
or Windows Operating System.
• To install from the Product CD, open the folder called WiebeTech Extras, then open the folder called
WiebeTech Configurator. Both Mac and Windows versions will be in this folder, just select the
appropriate file and follow the installation instructions.
4.1.1.1 Windows Installation
If you’ve chosen the Windows version of WiebeTech Configurator 2.0, a Setup Wizard will appear on your
screen. Click “Next”. After you click “Next” it will take you to a licensed agreement for installing this
software. Read over the agreement and select “I accept the agreement”, then click “Next”. The Setup
Wizard will automatically create folders for WiebeTech Configurator. If you would like to install it in a
different folder on your system that’s acceptable, just click “Browse” and select a new location. Once
you’ve decided on where to store the software click “Next”. Shortcuts will automatically be installed in the
Start Menu under a subfolder called WiebeTech. Again, if you’d like to install this in a different area
select “Browse” and choose a different location. After you’ve decided on where to store the program’s
shortcuts click “Next”. Then you can opt to have a desktop icon installed. Make your selection and click
“Next”. After that the wizard will prompt you to install the software and will give a brief recap of the
different selections you have made. Click “Install” and let the wizard complete your installation. Finally,
you can choose to launch the Configurator now. Click “Finish” and open up WiebeTech Configurator 2.0.
4.1.1.2 Mac Installation
If you’ve chosen the version of WiebeTech Configurator 2.0, a License Agreement will appear on your
screen. You can select “Agree” and run WiebeTech Configurator straight from the source, or you can
select “Save” and save the software to your Mac. WiebeTech recommends saving it to your Mac as well
as placing an icon on your desktop for future use.
4.1.2 RAID Setup - Using WiebeTech Configurator 2.0
Open WiebeTech Configurator 2.0. A reminder will appear telling you to disconnect all other FireWire
devices. Be sure to do that and then select “Continue”. If configuring a RAID you’ll need to have your
drives loaded inside of the unit. When WiebeTech Configurator 2.0 appears you can power on your RTX.