User`s manual

CRU-WiebeTech
R T X 4 0 0 - Q R U s e r ’ s M a n u a l - 4 -
1.3 Host Bus Adapter Installation
Install a host bus adapter (HBA) into an empty expansion slot inside your computer. If your computer
already has the connection type you need, you can skip this step. The following
general steps will work for most cards. Instructions for individual cards may vary,
so consult your host card’s user manual.
a) Power down the computer system.
b) Insert the card into an available slot. Do not force it, but it will take firm
pressure to insert it. Gently rocking the card into place may help.
c) Make sure the card is fully seated in the slot. Secure with a screw.
d) Turn the computer back on.
e) Install the appropriate software drivers for the card. The driver files are usually found on an
accompanying CD or on the manufacturer’s website.
All RTX TrayFree Bays accept up to 1.5TB
SATA drives, have power and access
LEDs, and connect to the controller via a
SATA connection.
WARNING: Do not block the ventilation
fan during operation. Overheating may
damage the device or hard drives.
View of Ports
Power Port
FireWire 800 USB
eSATA FireWire 400 Power Switch
Rear View
6cm Fans
RTX400-QR Bay
Ejection handle
Power LED
Access LED