User manual

CRU
User Manual for RAX QJ and RAX QJp (A9-210-0010) REV 1.0
- 3 -
NOTE: If any of the drives are inaccessible after
powering on the unit, try the following steps:
1. Turn off the power.
2. Remove the drive(s) in question.
3. Reinsert the drive(s).
4. Turn on the power.
1.2 Identifying Parts
Take a moment to familiarize yourself with the parts of your RAX unit. This will help you to better
understand the remaining instructions.
2. Hardware Setup
2.1 Installing Hard Drives
RAX QJ and QJp are compatible with 3.5-
inch SATA hard drives.
2.1.1 TrayFree™ Bay Drive Installation
This section refers only to RAX210-QJ and RAX210-QJp
models.
a) Pull on the ejection handle to open the door.
b) Slide in your SATA hard drive, connector-end first.
Note: the drive’s label should be facing up.
c) Shut the door.
2.1.2 Drive Installation for RAX with removable carriers
4cm Exhaust Fan
USB Port
AC Power Inlet
Power Switch
R
ea
r Vi
e
w
Fr
o
n
t
Vi
e
w
Ejection Handle
Key Lock
Bay Access LED
Mounting Bracket
Bay Power LED
eSATA Port
FireWire Ports
Write-Protect Status LEDs
(
QJ
p
onl
y)
Drive Temp LED
Drive Health LED
Fan LED
Write-Protect/Read-Write Switch (QJp only)