User`s manual

WiDRIVE DX-325 User’s Guide

7 Regulatory Information

FCC Compliance

This device complies with Part 15 of the FCC Rules. Operaon is subject to the following

two condions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operaon.

CAUTION:

1. To comply with FCC RF exposure compliance requirements, a separaon distance of at least 20 cm

must be maintained between the antenna of this device and all persons.

2. This Transmier must not be co-located or operang in conjuncon with any other antenna or

transmier.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursu-

ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protecon against

harmful interference in a residenal installaon. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instrucons, may cause harmful

interference to radio communicaons.

However, there is no guarantee that interference will not occur in a parcular installaon. If this

equipment does cause harmful interference to radio or television recepon, which can be determined

by turning the equipment o and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separaon between the equipment and receiver.

Connect the equipment into an outlet on a circuit dierent from that to which the receiver is

needed.

Consult the dealer or an experienced radio/TV technician for help.

FCC Warning:

Changes or modicaons to this unit not expressly approved by the party responsible for compliance

could void the user authority to operate the equipment.

CE Compliance

This product is CE marked in accordance with the requirements of the applicable EU Direcves. Re-

sponsible for CE marking is EDSLab Technologies Inc. A copy of the ocial Declaraon of Conformity

can be obtained from following website: hp://www.edslab.com

Working Environment

The Electromagnec Compliance (EMC) of this product has been veried typically for this product

category for a so called Residenal, Commercial & Light Industry Environment. Any other working envi-

ronment has not been veried by EDSLab Technologies Inc. and the use of this product in these work-

ing environments is maybe restricted or cannot be recommended. Possible consequences of the use

of this product in non veried working environments can be: Disturbances of other products or of this

product in the nearby surrounding area with temporarily malfuncon or data loss/corrupon as result.

Example of non veried working environments and related advices:

Industrial environment (eg environments where a mains voltage of 380V three-phase is being used mainly):

Danger of disturbances of this product due to possible strong electromagnec elds especially near to