User`s manual

WiDRIVE DX-325 User’s Guide
Copyright © 2010 EDSLAB Tech. Inc.
20
WiDRIVE IP Address
Current IP Address The default value is: 192.168.2.1, however you can always
manually assign an IP address to your WiDRIVE.
Subnet Mask You can manually assign the subnet mask of your WiDRIVE. We
strongly suggest you to use the default value: 255.255.255.0.
DHCP Sengs
Dene the IP range of DHCP server.
Starng IP The start of the range of IP available for your WiDRIVE network.
Ending IP The end of the range of IP available for your WiDRIVE network.
WiDRIVE AP Mode Seng
Your WiDRIVE performs as a wireless router in AP mode. Click on the AP Mode icon in the [Select
Setup Mode] secon to enter AP Mode Seng page:
• Basic seng
WiDRIVE Wireless Seng:
Congure wireless network of WiDRIVE.
SSID This is the wireless network name of your WiDRIVE. It must be idencal on all
points of the wireless network and cannot exceed 32 characters.
Security • If you select “None” from the dropdown bar, your wireless network
transfers data without safety encrypon.
• Otherwise select a security rule and then enter the password to enable the
safety protecon. The security capability from basic to strict:
WEP 64 bit WEP 128 bit WPA WPA2 WPA+WPA2
Channel • Select “Auto” from dropdown bar, your WiDRIVE automacally switches to
the best channel available.
• Otherwise you can manually assign a channel to your WiDRIVE.
Wireless Mode • 802.11 b/g mixed: select if your use 802.11 b and 802.11 g devices.
• 802.11 b/g/n mixed: select if your use 802.11 b, 802.11 g, and 802.11 n
devices.
• 802.11 n only: select if your devices are 802.11n.