User guide

Setting up Wideye Sabre 1 with BGAN LaunchPad Page 6
b. Insert the plug end into any AC outlet between 100 and 240 VAC.
c. Press and hold the On/Off Switch for 3 seconds.
d. The wideye logo is displayed on the LCD:
Note The battery charges automatically whenever the terminal is connected to a power source.
3.3 Obtaining a GPS fix
The BGAN network requires a valid GPS fix to successfully register your BGAN terminal.
To obtain a GPS fix:
a. Take the Wideye Sabre 1 outside and place the terminal on a flat surface, facing upwards and
with an unobstructed view of the sky. Ensure that the GPS antenna in the terminal is pointing
in the direction of the satellite.
b. Press the On/Off Switch for 3 seconds. The terminal performs GPS acquisition automatically.
c. Leave the terminal to acquire a GPS fix. This may take a few minutes. Once the GPS fix has
been acquired the LCD displays New GPS for 2 seconds.
d. The LCD displays the new estimated direction and elevation angle to which the antenna should
point. In addition a GPS indicator is displayed to right of the LCD display to indicate that new
GPS coordinates are being used.