User guide

Setting up Wideye Sabre 1 with BGAN LaunchPad Page 21
a. Select Terminal > Configure Ethernet. The following screen is displayed:
b. Check either Bridge Mode or Router Mode, or alternatively turn the Ethernet interface Off.
c. Click on Advanced to configure DHCP and DNS settings. The DHCP Configuration screen
is displayed:
d. Turn the DHCP Server On, if required. The screen displays the current DHCP Address
Range, and the IP addresses of the 1st and, if required, 2nd DNS Server.
e. If required, edit the DHCP address range by typing in a new start IP address in the From
fields, and a new end IP address in the To fields.