Specifications

4.4.2 Using the Bluetooth Headset

FIGURE 4.4.2-1: Figure showing the wireless connectivity

of the Bluetooth Handset with SABRE™ I.

Perform the pairing and connection procedures

before proceeding with this section. (Enabling

Bluetooth on SABRE™ I, Bluetooth device pairing

and connection procedures are found in Section

4.3 Bluetooth Settings on SABRE™ I.)

Making phone calls directly –

a. Bluetooth Handset: Enter the calling party

number in the following format: <00><Country

Code><Telephone Number><#> (Calling

numbers will be displayed in the LCD).

b. Press the button to start the dialing

sequence.

Making phone calls via Bluetooth Handset.

(Please refer to Appendix 6 of the Accessories

User Guide.)

II.

III.

4.5.1 Ethernet settings on SABRE™ I - Bridge (TAF) Mode

4.5.1.1 Change to Bridge mode:

I. From the LCD, use the Up/Down buttons to select Menu > Settings > Interfaces > Ethernet >

Connectivity > Bridge Mode Connection and Press ENTER

II. Use the Up/Down buttons to select Enable and Press ENTER.

4.5.1.2 Proceed with the following steps to activate a Data connection:

I. From the PC, open DUN Client - double-click on the DUN Client icon.

Note: There is a standard primary profile, cid = 1, as default configuration.

II. Click Dial to start connection. Username and Password are not required.

III. Wait until connection is successful, open the Internet Browser to begin “Surfing”.

4.5

Configuring SABRE™ I for network access

(via built in LCD Interface)-( Configuring for Standard Connection)