Specifications

From the LCD, use the Up/Down buttons to select
Menu > Settings > Interfaces > Bluetooth > Enable.
The LCD will display “Bluetooth enabled!” for 2
seconds and revert back to > Bluetooth.
FIGURE 4.3.1-1: LCD Display of SABRE™ I showing
the Bluetooth Interface “Enable” Option screen.
4.3.2 Pairing of Bluetooth Devices
From the LCD, use the Up/Down buttons to select
Pairing of Device.
The LCD will display “Searching…”.
After searching, the LCD will display a list of
devices for pairing. Select a Bluetooth device
from the list for pairing. (Devices of the same
brand and type may appear as the same name
on the list.)
Enter the Bluetooth device PIN.
(Wideye Bluetooth Headset default PIN is 0000.)
The LCD will display “Pairing…”.
When successfully paired, the LCD will display
Paired successfully !” for 2 seconds and revert
back to > Bluetooth.
However if Pairing fails, the LCD display will show
Pairing failed!
a) The PIN could be wrong, re-check on the PIN
and enter the correct PIN to repeat the pairing
operation.
b) If the PIN is correct, it is possible that SABRE™ I
is unable to detect the selected device during
the pairing operation, repeat the device
selection and continue with the pairing
procedure.
4.3
Bluetooth Settings on SABRE™ I
4.3.1 Enable Bluetooth
FIGURE 4.3.1-2: LCD Display of SABRE™ I showing
the “Bluetooth enabled!” message.
FIGURE 4.3.2-2: LCD Display of SABRE™ I showing
the “Pairing” message.
FIGURE 4.3.2-3: LCD Display of SABRE™ I showing
the “Paired successfully” message.
FIGURE 4.3.2-1: LCD Display of SABRE™ I showing
the “Searching” message after user selects the
“Pairing of Device” option.
I.
II.
I.
II.
III.
IV.
V.
VI.
VII.
35