Specifications

18
IV. The installer will then wait for the Terminal to acquire GPS fix. If the Terminal successfully acquires the GPS
fix, please go to step (6).
V. If the GPS fix is not successful (as shown below), make sure that the Terminal is positioned at high elevation
angle, exposed to clear sky and then leave it ON for another 2 to 3 minutes before clicking on the “Yes” button
to retry GPS acquisition. If it still fails to acquire GPS fix after repeated attempts, please switch OFF the Terminal,
switch it ON again and then retry.
3.6.1.1.1.1 Configure Terminal
The installer will configure the Terminal automatically. However, if it encounters any problem during the configuration,
it will prompt the user with appropriate message to take remedial action.
I. The installer will first detect the Terminal. If the Terminal is switched off, it will prompt a message, asking
user to turn it ON.
II. It will then detect if the Terminal is inserted with SIM Card. If the Terminal has no SIM card inserted, please
switch off the Terminal, insert the SIM card as shown in the Quick Start Guide and then restart the Terminal
before proceeding to the next step.
III. The installer will then prompt the user to select the preferred mode of Ethernet Interface as shown below.
The default mode is “Bridge”. If your PC/Laptop is built-in with Dual Core CPU, then you MUST select “Router
(IP)” mode. Click on “OK” after mode selection.