Specifications

LCD display will indicate the new estimated

azimuth direction and elevation angle that the

antenna should point. A indicator will be

displayed on the Top Right corner of the LCD display

to indicate that a New GPS coordinate is in use.

3.4

Powering Up and Registering to Network

3.4.1 Powering Up

Press and hold the On/Off switch for 3 seconds

The LCD display will show the “wideye” Logo.

FIGURE 3.4.1-1: LCD display showing the “wideye” logo

II.

For first time use, SABRE™ I needs to acquire the

GPS coordinates, go to an outdoor location and

face the SABRE™ I up to the sky. The terminal

shall perform the GPS acquisition automatically.

3.4.3 GPS Fix

FIGURE 3.4.3-2: LCD display indicating that SABRE™ I

has obtained a New GPS Fix.

FIGURE 3.4.3-1: LCD display indicating that SABRE™ I is

acquiring a New GPS Fix.

FIGURE 3.4.3-3: LCD display indicating the azimuth

direction and elevation angle of the GPS coordinates.

III.

II. When acquisition is done, the LCD display will show

New GPS fix for 2 seconds.

3.4.2 Terminal and SIM PINs (4 to 8 digits)

Enter the Terminal PIN number.

(Default Terminal PIN: 0000)

(Note: If the PIN is entered incorrectly or if user forgets the

Terminal’s PIN number, send the unit back to the distributor.)

FIGURE 3.4.2-2: LCD display showing SABRE™ I request

for SIM PIN.

Enter the SIM PIN number

(Note: If the SIM PIN is entered incorrectly after 3 attempts,

the PIN will be locked. Use the PUK (Personal Unblocking Key)

code to enter new SIM PIN. If the PUK code is entered

incorrectly after 10 attempts, the SIM will be disabled. Contact

the Service Provider.)

Note: A SIM Card is not required to make an emergency call.

SIM PIN number will not be required in the event of an

emergency call.

FIGURE 3.4.2-1: LCD display showing SABRE™ I

request for Terminal PIN.

II.

GPS