User's Manual

ezWAVE Access Point Users’ Guide Version 1.6

Page 28 of 50

2.3 Verifying the Operation of the Widelink Access Point

The AP runs a series of self-tests on power-up and reports status using its LEDs.

When power-up begins, the following occurs:

a. The firmware begins running diagnostics and initializes minimal hardware.

b. After the firmware completes its diagnostics and hardware initialization. The

diagnostics then checks the RF module to see whether it is properly running the AP.

And then, the firmware downloads RF module operating program.

c. Upon successful completion of the diagnostics and program download, the LED

which shows the wireless LAN link status blinks for 2~3 seconds and then display

bright green light steadily.

The diagnostics take approximately 30 seconds to complete after power-up. Upon

successful completion of the diagnostics, the LED pattern shown in below figure is

displayed.

If the AP fails to display the proper LED pattern, verify if you have correctly installed the

AP. If the AP still fails to display the LED pattern, refer to troubleshooting section.