User's Manual

ezWAVE Access Point Users’ Guide Version 1.6
Copyright© Widelink 2000 DOC 2001.02.01
Page 16 of 50
Plug the Power Pack into a wall outlet or a power strip, and plug the connector into the
power receptacle on the back of the Access Point.
All three indicators on top of the access point will be bright green.
During normal operation, indicators will be bright green. If indicators do not either display
a solid color or blink, see the Top Panel Indicator Descriptions” in this manual.
Caution
If you have already installed Widelink ezWAVE WAP-1100 series client card, you can
easily configure Access Point through air connection between your computer and
Access Point. You may skip next step and go to Access Point Management section.
STEP 3 Connect The Power Pack