User`s manual

Issued Date
Revision Status
Title
Page No.
10 / 44
V2.2
2009-2-20
IDP2310UX
(AL23PUX)
 Manual: Operator can select the input manually using control panel.
1.1.4 Controls of the Display
1.1.4.1 Remote Control via serial ports (JH Communication compatible)
 There are serial ports on the back side of the IDP2310UX for remote control of the monitor by customer
application.
 RS-422 port: Sub D, 15p, Female (for JH protocol)
 RS-232/485 port: Sub D, 9p, Female (for JH protocol)
 RS-485 port: Sub D, 9p, male as output (for Inter-Monitor Communication)
1.1.4.2 Control via OSD
 Control block with the push buttons is available: Menu, Select, ◀ and ▶ . Settings are selected by the Menu
that guides you through the OSD menu.
 Control block also has Volume for dimming brightness.
 Control block also has LED indicators, refer to 1.1.5.
1.1.5 LED Indicator
 Fault information in available by LED indicators
 Normal : Green indicator
 Soft Power Off: Amber indicator
 No signal : Amber Blinking (every 1 second) indicator
 System Fault : Red indicator
1.1.6 Power Supply Specification
1.1.6.1 Voltage range
 Standard :100 –264Vac, 47~63Hz,1.0A at 230Vac
1.1.6.2 Power consumption
Normal Max.
(100% Light output)
IDP2310UX 80 W 90W
1.1.6.3 Power variation protection
 Unit will not be damaged when Voltage transients remain within value as defined in the applicable voltage
range
1.1.6.4 Over-temperature protection
 When the internal temperature gets above than the warning level (65℃), the light output of the backlight is
half. And, LED as red color
 When the internal temperature reaches above the critical Value (80℃), the light output of the backlight is
turned off. And, LED as red color
 When the internal temperature gets below than the safe level (64℃), the light output of the backlight is
restored. And, LED recovers to green.
1.1.7 Connectors
1.1.7.1 Power connectors