User manual

36 Wide Bank 28 DS3 - Release 2.4
Loopbacks
3. Near-End Loopbacks
The following commands operate or release near-end loopbacks.
OPR-LPBK-T3:tid:aid:ctag::,,,lpbktype;
OPR-LPBK-T1:tid:aid:ctag::,,,lpbktype;
OPR-LPBK-E1:tid:aid:ctag::,,,lpbktype;
RLS-LPBK-T3:tid:aid:ctag::,,,lpbktype;
RLS-LPBK-T1:tid:aid:ctag::,,,lpbktype;
RLS-LPBK-E1:tid:aid:ctag::,,,lpbktype;
RLS-LPBK-ALL:tid:ALL:ctag;
Example Command
Operate DS1 #1 equipment loopback OPR-LPBK-T1:tid:DS1-1:ctag::,,,EQUIPMENT;
Release DS1 #1 equipment loopback RLS-LPBK-T1:tid:DS1-1:ctag::,,,EQUIPMENT;
Operate DS1 #1-4 line loopback RLS-LPBK-T1:tid:DS1-1&&DS1-04:ctag,,,LINE;
Release DS1 #1 loopback RLS-LPBK-T1:tid:DS1-1:ctag;
Release all DS1 loopbacks RLS-LPBK-T1:tid:ALL:ctag;
Release all loopbacks RLS-LPBK-ALL:tid:ALL:ctag;
Facility AID LPBKTYPE (Loopback Type)
T3 ALL
Note: refers to the Active
Controller
EQUIPMENT
LINE
PAYLOAD
T1 DS -01 to DS -28 EQUIPMENT
LINE
METALLIC
Note: Metallic loopbacks can only be applied to four
DS1s, one DS1 per protection group (see T3-T1
Configuration AIDs on page 6).
ALL EQUIPMENT
LINE
E1 E1-01 to E -27 EQUIPMENT
LINE
METALLIC
Note: Metallic loopbacks can only be applied to three
E1s, one E1 per protection group (see T3-E1
Configuration AIDs on page 8).
ALL ALL (optional)