User manual

Wide Bank 28 DS3 - Release 2.4 23
T1 Circuit Configuration
5. To Remove T1 From Service
CAUTION! REMOVING A T1 WILL DISRUPT SERVICE.
RMV-T1:tid:aid:ctag;
Example: Place DS1 #8 out of service.
RMV-T1:tid:DS1-08:ctag;
T1 Configuration Parameters
Keyword Description
AISF= Indicates whether failed signal from upstream should be replaced by AIS. Hard-
coded to Y.
CMDMDE= Indicates command execution mode. Hard-coded to FRCD. This means that
existing parameter settings may be overridden in order to execute the command.
DLCID= The DS1 digital loop carrier system identifier. This is a string of ASCII
characters and has a maximum length of 32 characters.
FLMDE= Indicates the fault locate mode. Hard-coded to BOTH.
FMT= Indicates DS1 digital signal format. Hard-coded to UNFR.
IDLE= Indicates the signal inserted for idle DS1. Hard-coded to AIS.
LBO= Indicates the line buildout setting. Values are 1-6.
• 1 – DSX(0’-110’)
• 2 – DSX(110’-220’)
• 3 – DSX(220’-330’)
• 4 – DSX(330’-440’)
• 5 – DSX(440’-550’)
• 6 – DSX(550’-660’)
LINECDE= Indicates DS1 line code. Values are:
• AMI – Alternate mark inversion
• B8ZS – Bipolar with 8-zero substitution
OMODE= Specifies what will be transmitted from the DS1 output port. Values are:
• NORM – Normal
• AIS – Alarm Indication Signal
RVRTFLAG= • UNLCKD – Unlocked. DS1 will revert to home.
• LOCKED – Indicates if the DS1 is locked onto the spare due to repeated
unsuccessful attempts at reverting to the working card (three attempts in 24
hours). The DS1 will remain on the spare until this flag is cleared, the DS1
card is replaced, or the DS1 is manually moved home (SW-TOWKG-T1).