User manual

16 Wide Bank 28 DS3 - Release 2.4

System ID

The following steps show how to set the System ID (sid) that appears as in all TL1 messages and is

required as the Target ID (tid) when used in TL1 commands.

1. Retrieve Current Equipment Configuration

NOTE: The following command is executed automatically when the user logs in.

RTRV-EQPT:tid:[ALL]:ctag;

Example: RTRV-EQPT:tid:ALL:ctag;

Response: tid 2002-01-05 11:21:39

M ctag COMPLD

"DS3-A:ACTIVE,2.40.0"

"DS3-B:STANDBY,2.40.0"

"DS1-CARD-1:ACTIVE,"

"DS1-CARD-2:ACTIVE,"

"DS1-CARD-3:ACTIVE,"

"DS1-CARD-4:ACTIVE,"

"DS1-CARD-5:ACTIVE,"

"DS1-CARD-6:ACTIVE,"

"DS1-CARD-7:ACTIVE,"

"DS1-CARD-SPARE:ACTIVE,"

;

2. Set System ID

SET-SID:tid::ctag::sid;

Example: Change System Equipment ID from tid to MUX-1.

SET-SID:tid::ctag::MUX-1;

Response: tid 2002-01-05 11:23:48

M ctag COMPLD

;

The first response following the SET-SID command will display the original tid so that

the response can be matched to the command. Subsequent commands and responses

will use the new tid.

Keyword Description

sid System ID: Up to 20 alphanumeric or hyphen characters