User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 11-3
SNMP
Configuration for SNMP
Location
This is a string of up to 255 characters that describes the physical location of this node.
Contact
This is a string of up to 255 characters that identifies the contact person for this managed node,
together with information on how to contact this person.
Basic Configuration from the CLI
1. Configure the Wide Bank network IP interface values. For example:
(A:Active)> ip address 192.168.20.10
(A:Active)> ip mask 255.255.255.0
(A:Active)> ip gateway 192.168.20.1
2. Configure the IP Addresses of up to three NMS systems that the Wide Bank will report traps
to. For example:
(A:Active)> ip nms1 192.168.20.3
(A:Active)> ip nms2 192.168.20.4
(A:Active)> ip nms3 192.168.20.5
3. Configure SNMP system group information contained in RFC-1213. Enter values for the name,
location, and contact. For example:
(A:Active)> SNMP name "Wide Bank 28 DS3"
(A:Active)> SNMP location "Acme Corp: telephone closet"
(A:Active)> SNMP contact "John Doe, Acme Corp [phone]"