User manual

Maintenance
Removing and Installing Faceplates
10-4 July 2004 Wide Bank 28 DS3 - Release 2.4
1. Remove the fan faceplate with a Phillips-head screw driver. Loosen the two captive screws on
each end of the faceplate that secure the faceplate to the Wide Bank chassis. A little force may
be required to disconnect the two fan power connectors.
2. When installiing the fan faceplate, use care to ensure correct alignment of the two power
connectors before tightening the fastening screws at each end of the faceplate. Do not
overtighten the captive screws. Carrier Access recommends a maximum torque of 8 to 10 inch-
pounds.
NOTE: When a fan faceplate is installed with the Wide Bank power turned on, there is
a 30-second delay before the fans are turned on.