User manual

TL1 Commands and Messages
TL1 Automatic Messages
9-106 July 2004 Wide Bank 28 DS3 - Release 2.4
Example:
tid 2001-08-04 11:51:58
A atag REPT PM T1
"DS1-01:UASL,20,COMPL,,,15-MIN,,"
"DS1-01:SESL,50,COMPL,,,15-MIN,,"
"DS1-01:LOSS,0,COMPL,,,15-MIN,,"
"DS1-01:ESL,100,COMPL,,,15-MIN,,"
"DS1-01:CSS,0,COMPL,,,15-MIN,,"
"DS1-01:DGRML,0,COMPL,,,15-MIN,,"
"DS1-01:PSD,0,COMPL,,,15-MIN,,"
"DS1-01:PSL,900,COMPL,,,15-MIN,,"
"DS1-01:CVL,0,COMPL,,,15-MIN,,"
;
Cancel User Session Event Message Format
If two or more users have active sessions and one user session times out because of user inactivity,
the other users will receive a CANC message. In the following example, STEVE is the user that
timed out:
Example:
tid 2001-08-04 04:40:32
A atag CANC
STEVE
/* Session Timeout: STEVE */
;
The session time-out period can be set by the administrator. The default is 31 minutes. See SET-
ATTR-SECUDFLT on page 9-77.
DS3 Far-End Alarms
Far-end alarms are events that occur at a remote location and are reported to the Wide Bank over
the DS3 link. This feature and the associated commands require the DS3 to be set for C-bit framing.
Message Summary Table
Table 2-1 summarizes the alarm and event messages provided by the Wide Bank 28 DS3.
NOTE: Table 2-1 lists the default values for the Notification Code alarm severities. You
can assign a different alarm severity to many of the Condition Types by using the TL1
command SET-ATTR-<AIDType> on page 9-75. Alarm severities for the standby
Controller can be set using the CLI command ALARMS STANDBY on page 8-11.