User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 9-99
TL1 Commands and Messages
TL1 Parameter Descriptions
Time <time>
This parameter specifies the date. The date format is HH:MM:SS, where HH is the hour (24-hour
clock), MM is the minutes, and SS is the seconds.
Time Offset <tmofst>
This parameter specifies the time offset from the end of the last complete accumulation time period
to the beginning of the accumulation period specified with the <tmper> variable. The Wide Bank
will accept NULL and 0-1-0 values but these values are ignored and the time offset defaults to the
current register.
Time Period <tmper>
This identifies the time period for performance monitoring.
Error Response: Invalid Time Period
tid 2001-08-04 11:51:58
M ctag DENY
INUP
/* Invalid Payload block. Invalid positional field. */
;
Type or Request <typereq>
This parameter describes the type of condition or state to be retrieved. This field is represented by
<typereq>.
Values can be any specific <condtype> (see Condition Type <condtype> on
page 9-87).
User Access Privilege <uap>
This parameter determines which commands the user can issue.
Identifier Description
1-DAY One Day
1-HR One Hour
15-MIN 15 Minutes
Identifier Description
R Monitor: Cannot change any parameters or configuration items.
RW Operator: Can issue any command, except security commands.
RWA Administrator: Can issue any command.