User manual

TL1 Commands and Messages
TL1 Parameter Descriptions
9-98 July 2004 Wide Bank 28 DS3 - Release 2.4
Service Effect of Alarm or Condition <srveff>
This field is represented by <srveff>.
Error Response: Invalid Service
Service Effect Codes are used in automatic messages and are not supported in TL1 commands.
When a service effect is specified in a command, the following error response is returned:
tid 2001-08-04 01:41:20
M ctag DENY
ENEQ
/* Service effect (srveff) not supported */
;
Target Identifier <tid> and Source Identifier <sid>
NOTE: For simplicity, examples and responses in this document will represent the
target id and source identifiers by the lower-case letters tid and sid.
The target identifier <tid> specifies the network element to which the command is sent. The source
identifier <sid> is part of the response, and specifies which network element transmitted the
response. Both tid and sid are alphanumeric or hyphen characters.
The target identifier is optional in TL1 commands. However, if a value is entered that does not
match the target identifier stored on the network element, the following error response is returned.
tid 2001-08-05 00:43:22
M ctag DENY
IITA
/* Input, Invalid Target Indentifier */
;
The target identifier or source identifier is set by the command tl1 networkid “networkid” issued
from the CLI of the network element to which the target identifier belongs. Any commands issued
to that network element must contain its target identifier. That same target identifier will become
the source identifier in any response that specific network element sends back.
Threshold Level <thlev>
This parameter specifies the threshold level. If this level is exceeded, the Wide Bank will send an
event report for the associated parameter.
Identifier Description
NSA Non-Service affecting Condition
SA Service affecting Condition