User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 9-97
TL1 Commands and Messages
TL1 Parameter Descriptions
Private Identifier <pid>
This parameter specifies the private password identifier. This is a string of up to ten ASCII
characters and must contain at least two non-alphabetic characters, with at least one non-
alphanumeric character. Example: FRED-1
Reporting Interval <reptinvl>
This parameter specifies how often reports are to be generated and sent: 15-MIN, 1-HR, or 1-DAY.
Reporting Start Time <reptstatm>
This parameter specifies the time when the reports should start being generated. The Wide Bank
currently supports only NULL, 0-0, or 00-00. All of these start the reports immediately.
Restoration Function Codes
These function codes identify the area within the NE that restoration is allowed or inhibited.
Security Alarm Type <secualmtype>
This parameter explains type of security alarm.
Code Description
DS1EQPT Allow or inhibit autorestoration of a DS1 card
DS3EQPT Allow or inhibit autorestoration of the DS3 card
SYNC Allow or inhibit autorestoration of the clock
Type Description
INTRUSION There were 3 consecutive failed login attempts
LOGBUFR90-SECULOG The security log is 90% full
LOGBUFROVFL-SECULOG The security log buffer is overflowing
T-UIDAGE A user ID has not been used over a long period of time
and should be disabled. The Wide Bank does not
currently support T-UIDAGE.