User manual

TL1 Commands and Messages
TL1 Parameter Descriptions
9-96 July 2004 Wide Bank 28 DS3 - Release 2.4
Notification Code <ntfncde>
The notification code specifies the severity or class of alarm, event or condition. This field is
represented by <
ntfncde>.
Error Response: Invalid Notification Code
tid 2001-08-04 01:41:20
M ctag DENY
INUP
/* Invalid Payload block. Invalid positional field. */
;
Number of Reports <numrept>
This parameter specifies the number of reports to be generated and sent.
Occurrence Date <ocrdat>
This parameter specifies the date when the event occurred. The format is MM-DD, where MM is
the month and DD is the day.
Occurrence Time <ocrtm>
This parameter specifies the time when event occurred. The format is HH-MM-SS, where HH is the
hours (24-hour clock), MM is the minutes, and SS is the seconds.
Phase <ph>
This parameter specifies the degree to which the system should be initialized. This parameter is
currently accepted but ignored.
Identifier Description
CL Condition Cleared
CR Critical Alarm
MJ Major Alarm
MN Minor Alarm
NA Not Alarmed
NR Not Reported