User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 9-95
TL1 Commands and Messages
TL1 Parameter Descriptions
Monitored Parameter Type <montype>
This identifies the type of parameter being monitored.
Error Response: Invalid Monitored Parameter Type
tid 2001-08-04 12:12:07
M ctag DENY
INUP
/* montype must be "ALL" or NULL */
;
The following error occurs for invalid montype in set threshold or retrieve threshold commands.
2001-08-05 22:39:34
M 0 DENY
INUP
/* Invalid Payload block. Invalid positional field. */
;
Identifier Description
CSS Control Slip Seconds count
CVL Coding Violation count – Line. This montype supports Threshold
Cross Alerts on the DS1s and DS3.
CVP-P Coding Violation count – Path. This montype supports Threshold
Cross Alerts on the DS3 only.
DGRML Degraded Minute count – Line
ESL Errored Second count – Line
ES-LFE Errored Second count – Line, Far End
ESP-P Errored Second count Path – P-bit parity. This montype supports
Threshold Cross Alerts on the DS3 only.
LOSS-L Loss of Signal Seconds count – Line
PSC Protection Switching Count
PSD Protection Switching Duration in seconds
SEFS Severely Errored Framing Second count
SESCP-P Severely Errored Second count – Path, DS3 CP-bit parity. This
montype supports Threshold Cross Alerts on the DS3 only.
SESL Severely Errored Second count – Line. This montype supports
Threshold Cross Alerts on the DS3 only.
SES-LFE Severe Errored Second Count – Line, Far End
UASL Unavailability Second count – Line
UAS-LFE Unavailability Second count – Line, Far End