User manual

TL1 Commands and Messages
TL1 Parameter Descriptions
9-90 July 2004 Wide Bank 28 DS3 - Release 2.4
Error Response: Invalid Direction
This parameter is used in automatic messages and is not supported in TL1 commands. If issued
as part of a command, the following error response is returned.
tid 2001-08-04 12:06:48
M ctag DENY
ENEQ
/* Direction (dirn) not supported */
;
DS1/E1 Properties
Error Message: Invalid T1/E1 Parameter or Value
tid 2001-08-04 13:18:00
M ctag DENY
INUP
/* Invalid Payload block. Invalid name value field. */
;
Field Description and Possible Vales
DLCID Circuit ID: ASCII string – up to 32 characters.
LBO Line Build Out (length): (Applies to T1 only. E1 has no LBO.)
• 1 – DSX (0'-110')
• 2 – DSX (110'-220')
• 3 – DSX (220'-330')
• 4 – DSX (330'-440')
• 5 – DSX (440'-550')
• 6 – DSX (550'-660')
LINECDE Line Code. (Applies to T1 only. E1 is hard coded to HDB3.)
• AMI – Alternate Mark Inversion,
• B8ZS – Bipolar with 8-zero Substitution
OMODE Output Mode:
• NORM – Normal Data
• AIS – Alarm Indication Signal
• QRSS – Quasi-random Signal, unframed
• Null value defaults to NORM.
• QRSU is not supported.
RVRTFLAG Revertive Lockout Flag:
• LCKD – Locked, DS1 will remain on spare until flag is cleared,
new card is inserted, or DS1 is sent home manually.
• UNLCKD – Unlocked, DS1 will stay on spare if card self-test fails,
otherwise it will return to the home channel after two minutes.