User manual

TL1 Commands and Messages
TL1 Parameter Descriptions
9-88 July 2004 Wide Bank 28 DS3 - Release 2.4
Error Response: Invalid Condition Type
tid 2001-11-02 01:41:20
M ctag DENY
INUP
/* Invalid Payload block. Invalid positional field. */
;
HITEMP High Temperature
IMPROPRMVL Improper card Removal
INHAUTORSTEQPT Revertive Off
INHAUTORSTSYNC DS3 clockrevert Off
INHLPBK Loopdetect Off
INHSWPR Facility protection not enabled
INHSWWKG Equipment protection not enabled
INT Internal hardware failure
INTERR Internal error detected
LOF Loss of frame
LOS Loss of signal
LPBKEQPT Equipment loopback
LPBKLINE Line loopback
LPBKMETALLIC Metallic loopback
LPBKPAYLOAD Payload loopback
NORMAL Normal condition is used only for REPT EVT “clear” condition, with
clarification in the description field to indicate which condition has
cleared.
PROTNA Protection Unit not Available
PWR Power +5V failure
PWR Power –48V failure or low
RAI Remote Alarm Indication
SYNCPRI Loss of designated clock
TRMT Transmitter Failure
T-x Threshold Crossing Alert, where “x” represents a montype. For x
values, see Monitored Parameter Type <montype> on
page 9-95.
WKSWBK Working unit switched back to working
WKSWPR Working unit switched to protect unit
Condition Description