User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 9-77
TL1 Commands and Messages
TL1 Command List
SET-ATTR-SECUDFLT
Name: Set Attribute Security Default Time-out
Purpose: Set the number of minutes before session inactivity times out the TL1 TCP/IP port.
When the command is issued, any active sessions will be updated with the new session
time-out period. Setting the tmout parameter to zero will turn off session inactivity
time-outs so that sessions will never time out. The system default time-out is 31
minutes.
Note: This command applies only to TL1 sessions using the TCP/IP port on that Wide
Bank. It does not affect TL1 sessions using the TL1 RS-232 port or any CLI sessions
using TCP/IP or RS-232.
Category: Memory Administration Commands
Security: RWA
Syntax: SET-ATTR-SECUDFLT:[<tid>]::[<ctag>]::TMOUT=<tmout>;
Example: SET-ATTR-SECUDFLT:tid::ctag::TMOUT=15;
Set user TCP/IP sessions to time-out after 15 minutes of inactivity. For description of
time-out message, see Cancel User Session Event Message Format on page 9-106.
Field Description
ctag Correlation Tag (optional)
tid
Target ID of network element (optional)
tmout Time-out period in minutes:
• Any positive integer value
• A zero value will disable timeout
• Default value is 31