User manual

TL1 Commands and Messages
TL1 Command List
9-74 July 2004 Wide Bank 28 DS3 - Release 2.4
SCHED-PMREPT-<FacilityType>
Name: Schedule Performance Monitoring Report
Purpose: Schedules a performance report for the selected FacityType. These are automatic
reports that provide performance statistics (see Report Performance Monitoring
Message Format on page 9-105). PM reports can be allowed or inhibited (see ALW-
PMREPT-<FacilityType> on page 9-22 and INH-PMREPT-<FacilityType> on
page 9-38).
Category: Transport Surveillance Commands
Security: RW
Syntax: SCHED-PMREPT-<{T3|T1|E1}>:[<tid>]:<aid>:[<ctag>]::
[<reptinvl>],[<reptstatm>],[<numrept>],,
[1-UP],[NEND],,[<tmper>],[0-1-0];
Example: SCHED-PMREPT-T1:tid:ALL:ctag::15-MIN,,10,,,,,15-MIN;
Schedule ten T1 Performance Reports at 15-minute intervals.
Field Description
0-1-0 Time Offset (optional) specifies the time offset from the end of the
last complete accumulation time period to the beginning of the
accumulation period specified with the tmper variable. The Wide
Bank will accept the following values but the time offset will always
be zero:
• 0-1-0 – no offset
1-UP Monitor Level (optional) specifies the discriminating level for the
requested monitored parameter. The Wide Bank currently supports
the following:
• 1-UP – report all performance statistics that do not have a value of
zero
ctag Correlation Tag (optional)
NEND Location (optional):
• NEND – near end and far end
numrept The number of reports (optional) the user would like scheduled. A
value of zero turns reports off. Otherwise, reports are sent every
reporting interval and the number of reports is decremented. Even if
reporting is inhibited (see INH-PMREPT-<FacilityType> on
page 9-38), the number will continue to decrement. If the numrept
value is omitted from the command, the Wide Bank will report every
reporting interval indefinitely until another schedule command is
issued.
• null – (default) report all intervals
• 0 – no reports
• integer – number of reports