User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 9-55
TL1 Commands and Messages
TL1 Command List
RTRV-ARC-<LSType>
Name: Retrieve Automatic In-Service
Purpose: Retrieves the automatic in-service status (on/off) and delay time (1 to 168 hours) for all
low-speed T1 or E1 channels.
Category: Transport Surveillance Commands
Security: RW
Syntax: RTRV-ARC-{T1|E1}:<tid>:<aid>:<ctag>::QI;
Example: RTRV-ARC-T1:tid::ctag;
Retrieve auto in-service status.
The following response appears when automatic in-service detection is turned on. If it
is turned off, the response will be a simple COMPLD with no data.
Response Format:
<cr><lf><lf>
^^^<tid>^<YYYY-MM-DD>^<HH:MM:SS><cr><lf>
M^^<ctag>^COMPLD<cr><lf>
^^^"ALL,T1:QI,<delay>"
;
Response: tid 2002-06-12 11:21:32
M ctag CMPLD
"ALL,T1:QI,2"
;
Field Description
aid Access ID must either be ALL or be omitted. If omitted, the default is
ALL.
ctag Correlation Tag (optional)
delay
Delay time in hours, 1 to 168 (1 week). The factory default is 2 hours.
This parameter appears in the response message (see below) and can
be changed by the command OPR-ARC-<LSType> on
page 9-41.
QI
Qualified Inhibition (optional). If omitted, the default is QI.
tid
Target ID of network element (optional)