User manual

TL1 Commands and Messages
TL1 Command List
9-44 July 2004 Wide Bank 28 DS3 - Release 2.4
Security: R
Syntax: RD-MEM-FILE:[<tid>]:CONFIG:[<ctag>];
Because this command can take more than 2 seconds to execute, an “In Progress” (IP)
acknowledgment will be sent upon receiving a valid command:
Example: RD-MEM-FILE:tid:CONFIG:ctag;
Response: tid 2001-08-04 11:51:58
M ctag COMPLD
<up to 64 characters (32 bytes) of data>
;
The contents of the brackets can occur one or more times. In the case where the total
size of a response exceeds 4096 bytes, the response is divided into multiple responses.
RLS-ARC-<LSType>
Name: Release Automatic In-Service Detection
Purpose: Turns off the automatic in-service detection feature for all low-speed DS1 or E1
channels. Normal LOS alarm operation will resume immediately. To enable automatic
in-service detection or set the delay time, see OPR-ARC-<LSType> on page 9-41.
Category: Transport Surveillance Commands
Security: RW
Syntax: RLS-ARC-<T1|E1>:<tid>:<aid>:<ctag>::QI;
Example: RLS-ARC-T1:tid::ctag;
Turn off automatic in-service detection feature.
Field Description
ctag Correlation Tag (optional)
tid
Target ID of network element (optional)
Field Description
aid Access ID must either be ALL or be omitted. If omitted, the default is
ALL.
ctag Correlation Tag (optional)
QI
Qualified Inhibition (optional). If omitted, the default is QI.
tid
Target ID of network element (optional)