User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 9-43
TL1 Commands and Messages
TL1 Command List
OPR-LPBK-<FacilityType>
Name: Operate Loopback
Purpose: Activates the specified loopback. To release loopbacks, see RLS-LPBK-
<FacilityType> on page 9-45.
Category: Transport Surveillance Commands
Security: RW
Syntax: OPR-LPBK-{T3|T1|E1}:[<tid>]:[<aid>]:
[<ctag>]::,,,<lpbktype>;
Example: OPR-LPBK-T1:tid:DS1-1:ctag::,,,EQUIPMENT;
Initiate DS1 #1 equipment loopback.
RD-MEM-FILE
Name: Read Memory File
Purpose: Downloads the configuration file.
Category: Transport Surveillance Commands
Field Description
aid Access ID depends on Facility Type. See table below.
ctag Correlation Tag (optional)
lpbktype Loopback Type depends on selected Facility Type. See table below.
tid
Target ID of network element (optional)
Facility Type aid <lpbktype>
T3 ALL
Note: This refers to the
Active Controller
EQUIPMENT, LINE, PAYLOAD
T1 DS -01 to DS -28 EQUIPMENT, LINE, METALLIC
Note: Metallic loopbacks can only be
applied to four DS1s, one DS1 per
protection group.
ALL EQUIPMENT, LINE
E1 E1-1 to E -27 EQUIPMENT, LINE, METALLIC
Note: Metallic loopbacks can only be
applied to three E1s, one E1 per
protection group.