User manual

TL1 Commands and Messages
TL1 Command List
9-42 July 2004 Wide Bank 28 DS3 - Release 2.4
Note: A channel’s LOS inhibit will also be disabled immediately if any of the
following events occur:
• the channel is disabled (set out of service)
• a hardware failure occurs on the channel
• a metallic loopback is run on the channel
• the channel is manually moved to a spare
• the channel’s card is removed.
However, if a channel is disabled and then re-enabled while an LOS condition is
present, the automatic in-service detection will again inhibit the LOS alarm.
Automatic in-service detection is applied on a channel-by-channel basis. If service is
discontinued on a channel, automatic in-service detection can be reapplied to that
channel by placing it out of service (see RMV-<AIDType> on page 9-46) and then back
in service (see ENT-<LSType> on page 9-33).
To quickly provision automatic in-service detection when turning up a new Wide Bank,
first turn on automatic in-service detection and then place all (aid = ALL) T1s or E1s
out of service and then back in service.
Category: Transport Surveillance Commands
Security: RW
Syntax: OPR-ARC-<T1|E1>:<tid>:<aid>:<ctag>::QI,[<delay>];
Example: OPR-ARC-T1:tid::ctag;
Turn on automatic in-service detection.
Example: OPR-ARC-T1:tid::ctag::QI,12;
Turn on automatic in-service detection and set delay time to 12 hours.
Field Description
aid Access ID must either be ALL or be omitted. If omitted, the default is
ALL.
ctag Correlation Tag (optional)
delay
Delay time in hours, 1 to 168 (1 week). If omitted, the current value
remains unchanged. Factory default is 2 hours.
QI
Qualified Inhibition (optional). If omitted, the default is QI.
tid
Target ID of network element (optional)