User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 9-41

TL1 Commands and Messages

TL1 Command List

INIT-SYS

Name: Initialize System

Purpose: Resets the Active Controller.

Category: Transport Surveillance Commands

Security: RWA

Syntax: INIT-SYS:[<tid>]:ALL:[<ctag>]::[<ph>];

Example: INIT-SYS:tid:ALL:ctag::;

OPR-ACO-ALL

Name: Operate Alarm Cutoff

Purpose: Initiates alarm cutoff.

Category: Transport Surveillance Commands

Security: RW

Syntax: OPR-ACO-ALL:[<tid>]::[<ctag>];

Example: OPR-ACO-ALL:tid::ctag;

OPR-ARC-<LSType>

Name: Operate Automatic In-Service Detection

Purpose: Turns on the automatic in-service detection for all low-speed DS1 or E1 channels that

are subsequently put in service while there is an LOS condition. This command inhibits

the LOS alarm until a good signal has been received for the specified delay time. To

release automatic in-service detection on all DS1 or E1 channels, see RLS-ARC-

<LSType> on page 9-44.

Note: Following a DC power interruption, the LOS inhibit will be disabled on all

channels, causing an LOS alarm on any DS1 or E1 that is enabled but not in service.

Field Description

ctag Correlation Tag (optional)

Degree of system initialization. Because the Wide Bank 28 DS3 only

supports one degree of system initialization, this parameter is ignored

and may be omitted.

tid

Target ID of network element (optional)