User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 9-27
TL1 Commands and Messages
TL1 Command List
Performs diagnostic on DS1 #1.
Response: tid 2001-08-04 11:51:58
M ctag COMPLD
(^^^"<aid>:<rslt>,,"<cr><lf>)+
;
The contents of the brackets occur one or more times.
Example: DGN-T1:tid::ctag;
Diagnose ALL.
Because this command can take more than 2 seconds to execute, an “In Progress” (IP)
acknowledgment will be sent upon receiving a valid command:
IP 109
<
The acknowledgment is followed by the normal response.
DISC-LPBK-<FacilityType>
Name: Disconnect Loopback {T1|E1|T3}
Purpose: Disconnects a T1, E1, or T3 loopback. To connect loopbacks, see CONN-LPBK-
<LSType> on page 9-24 and CONN-LPBK-T3 on page 9-25.
Category: Network Maintenance Commands
Security: RW
Syntax: DISC-LPBK-{T3|T1|E1}:[<tid>]:<aid>:[<ctag>];
Field Description
rslt Result: pass, fail, or not present.
Field Description
FacilityType T3, T1, E1
aid Access ID depends on selected FacilityType. See table below.
ctag Correlation Tag (optional)
FacilityType aid
T3 ALL
T1 DS1-1 to DS1-28
E1 E1-1 to E1-27