User manual

TL1 Commands and Messages
TL1 Command List
9-26 July 2004 Wide Bank 28 DS3 - Release 2.4
Example: CPY-MEM:tid::ctag::ACTIVE,,STANDBY;
Copies configuration from active to standby Controller.
Example: CPY-MEM:tid::ctag::CONFIG,,TEMP;
Creates a temporary copy of the configuration.
Example: CPY-MEM:tid::ctag::TEMP,,CONFIG
Restores the configuration from the temporary copy.
DGN-<AIDType>
Name: Diagnose
Purpose: Test one or more units on the Wide Bank. This command does not test the standby
(protected) T3 interface, which is self-tested only when the standby Controller card is
initialized on power-up.
Category: Transport Surveillance Commands
Security: R
NOTE: Entities must be removed from service before self-test diagnostics. See RMV-
<AIDType> on page 9-46. Entities can be restored to service after self-test. See RST-
<AIDType> on page 9-46.
Syntax: DGN-{T3|T1|E1|ENV|ALL}:[<tid>]:<aid>:[<ctag>];
Example: DGN-T1:tid:DS1-1:ctag;
Field Description
AIDType
Access ID Type. Values are T3, T1, E1, ENV, ALL
aid Access ID depends on selected AIDType. See table below.
ctag Correlation Tag (optional)
tid
Target ID of network element (optional)
AIDType aid
T3 ALL
T1 DS1-1 to DS1-28
E1 E1-1 to E1-27
ENV FAN-A, FAN-B
ALL ALL