User manual

TL1 Commands and Messages
TL1 Command List
9-24 July 2004 Wide Bank 28 DS3 - Release 2.4
CANC-USER-SECU
Name: Cancel User Security
Purpose: Used by an administrator to terminate any active user session.
Category: Security Commands
Security: RWA
Syntax: CANC-USER-SECU:[<tid>]:<uid>:[<ctag>];
Example: CANC-USER-SECU:tid:FRED:ctag;
CONN-LPBK-<LSType>
Name: Connect Loopback {T1|E1}
Purpose: Activates T1 or E1 loopback. To disconnect loopbacks, see DISC-LPBK-
<FacilityType> on page 9-27.
Category: Network Maintenance Commands
Security: RW
Syntax: CONN-LPBK-{T1|E1}:[<tid>]:<aid>:[<ctag>]::<lpsig>;
Example: CONN-LPBK-T1:tid:DS1-1:ctag::A-1;
Field Description
ctag Correlation Tag (optional)
tid
Target ID of network element (optional)
uid User ID
Field Description
aid Access ID:
• For T1 modifier, values are DS1-1 to DS1-28.
• For E1 modifier, values are E1-1 to E1-27.
See Access Identifier <aid> on
page 9-84
lpsig Looping Signal:
• A-1 – Send CSU loopup request on line side
• R-1 – Send CSU loopdown request on line side
• A-2 – Send NIU loopup request on network side
• R-2 – Send NIU loopdown request on network side
• A-3 – Send NIU loopup request on line side
• R-3 – Send NIU loopdown request on line side
tid
Target ID of network element (optional)