User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 9-23
TL1 Commands and Messages
TL1 Command List
ALW-SWTOWKG-<FacilityType>
Name: Allow Switching To Working
Purpose: For the T3 modifier, this command arms the protection switch circuit. For T1 or E1,
this command clears the revertive lockout flag for the DS1s (or E1s) specified in the
<aid> Field. To inhibit switching, see INH-SWTOWKG on page 9-39.
Category: Transport Surveillance Commands
Security: RW
Syntax: ALW-SWTOWKG-{T3|T1|E1|ALL}:[<tid>]:[<aid>]:[<ctag>];
Example: ALW-SWTOWKG-ALL:tid:ALL:ctag;
CANC-USER
Name: Cancel User
Purpose: Terminates the user’s TL1 session.
Category: Security Commands
Security: R
Syntax: CANC-USER:[<tid>]:[<uid>]:[<ctag>];
Example: CANC-USER:tid:FRED:ctag;
Field Description
aid Access ID is optional and if omitted will default to ALL:
• ALL specifies all circuits covered by the modifier.
• For T3 modifier, the only valid value is ALL.
• For T1 and E1 modifiers, values can be ALL, a range, a list, or one
circuit.
• For T1 modifier, values are DS1-1 to DS1-28.
• For E1 modifier, values are E1-1 to E1-27.
See Access Identifier <aid> on
page 9-84
ctag Correlation Tag (optional)
tid
Target ID of network element (optional)
Field Description
ctag Correlation Tag (optional)
tid
Target ID of network element (optional)
uid User ID