User manual

TL1 Commands and Messages
TL1 Command List
9-20 July 2004 Wide Bank 28 DS3 - Release 2.4
ALW-LPBK-<FacilityType>
Name: Allow Loopback
Purpose: Enables the detection of loop codes.
To inhibit loopbacks, see INH-LPBK-<FacilityType> on page 9-36.
Category: Transport Surveillance Commands
Security: RW
Syntax: ALW-LPBK-{T1|E1|T3|ALL}:[<tid>]:[<facilityID>]: [<ctag>];
Example: ALW-LPBK-T1:tid:DS1-1:ctag;
Allow loopback on DS1 #1.
Example: ALW-LPBK-ALL:tid::ctag;
Allow the detection of all loop codes.
ALW-MSG-<AIDType>
Name: Allow Message
Purpose: Used by the administrator to enable the transmission of automatic messages and
alarms. To inhibit messages, see INH-MSG-<AIDType> on page 9-37. Notification
codes (alarm severities) for many conditions can be altered through the TL1 interface,
see SET-ATTR-<AIDType> on page 9-75.
Category: Transport Surveillance Commands
Security: RWA
NOTE: Only one parameter can be present in an inhibit/allow command: either the
Access Identifier <aid> or the Notification Code <ntfcncde> or the Condition Type
<condtype>.
Syntax: ALW-MSG-{T1|E1|EQPT|T3|ALL}:[<tid>]:
[<aid>]:[<ctag>];
Field Description
ctag Correlation Tag (optional)
facilityID
Facility ID depends on selected FacilityType:
• For T1, use DS1-1 to DS1-28
• For E1, use E1-1 to E1-27
• For T3 or ALL, use ALL or omit
facilityID
tid
Target ID of network element (optional).