User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 9-19
TL1 Commands and Messages
TL1 Command List
Syntax: ALW-AUTORST:[<tid>]::[<ctag>]::
{E1EQPT|DS1EQPT|DS3EQPT|SYNC};
Example: ALW-AUTORST:tid::ctag::DS1EQPT;
ALW-LOG-SECU
Name: Allow Log Security
Purpose: Used by the administrator to enable the recording of security events.
To inhibit recording, see INH-LOG-SECU on page 9-35.
Category: Security Commands
Security: RWA
Syntax: ALW-LOG-SECU:[<tid>]:SECURITY:[<ctag>]::ALL;
Example: ALW-LOG-SECU:MUTLIPLEXER-1:SECURITY:67::ALL;
Field Description
ctag Correlation Tag (optional)
tid
Target ID of network element (optional)
E1EQPT
E1 revertive switching. The E1 circuit will revert to its home card
after the fault clears. However, if three protection switches occur
within 24 hours, the circuit will remain on the spare card until
automatic E1 restoration is reasserted.
DS1EQPT
DS1 revertive switching. The DS1 circuit will revert to its home card
after the fault clears. However, if three protection switches occur
within 24 hours, the circuit will remain on the spare card until
automatic DS1 restoration is reasserted.
DS3EQPT
DS3 revertive switching. The DS3 circuit will revert to the primary
DS3-A Controller after the fault clears.
SYNC Clock revert. The transmit clock will revert to the original clock
source when it is considered to be healthy again.
Field Description
ctag Correlation Tag (optional)
tid
Target ID of network element (optional)