User manual

TL1 Commands and Messages
TL1 Command List
9-18 July 2004 Wide Bank 28 DS3 - Release 2.4
ACT-USER
Name: Activate User
Purpose: Logs user into a TL1 session.
Category: Security Commands
Security: R
Syntax: ACT-USER:[<tid>]:uid:[<ctag>]::<pid>;
Example: ACT-USER::ADMIN;
Login first time after installation if no password has been assigned. If a password is
required the first time, the default password is TEST.
Example: ACT-USER:tid:FRED:ctag::FRED-22;
ALW-AUTORST
Name: Allow Automatic Restoration
Purpose: Enables revertive switching modes.
To disable revertive switching modes, see INH-AUTORST on page 9-35.
Category: Transport Surveillance Commands
Security: RW
Field Description
ctag Correlation Tag (optional)
pid Private ID (password). An ASCII string up to 10 characters long with
at least two non-alphabetic characters with at least one special
character, such as FRED-22. Omit if password is not required.
tid
Target ID of network element (optional)
uid
User ID (user name). Up to 10 alphanumeric characters.