User manual

TL1 Commands and Messages
TL1 Setup and Configuration
9-16 July 2004 Wide Bank 28 DS3 - Release 2.4
Testing TL1 Alarming
The Wide Bank 28 DS3 provides the ability to test TL1 alarming from the command line interface
without requiring you to actually initiate a network alarm. The tl1 send alarm CLI command sends
a simulated alarm out the TL1 interface.
Canceling the TL1 User Session
The cancel user command terminates the TL1 command/response session, and the Wide Bank will
no longer respond to the retrieve alarm all and retrieve header commands. However, the automatic
messages will continue to be delivered through the same port. The TL1 session will also be closed
if the power to the unit is interrupted or the active Controller is switched.
CANC-USER:MULTIPLEXER-1:USERID:34;
Error Message in Response to Commands Not Recognized
or Supported
MULTIPLEXER-1 01-12-07 01:41:20
M 12 DENY
ICNV
"Input, Command Not Valid or Not Supported"
;
Error Response to Valid Commands Received When a User
Is Not Logged In
MULTIPLEXER-1 01-12-07 01:41:20
M 12 DENY
PLNA
"Login Not Active"
;