User manual

TL1 Commands and Messages
TL1 Setup and Configuration
9-12 July 2004 Wide Bank 28 DS3 - Release 2.4
Activating Users
Use the act-user command is the login command. Use it to start a TL1 session.
ACT-USER:tid:UserName:ctag::password;
For the first login to a newly installed Wide Bank, the UserName field must be “admin” and the
password must be the initial TL1 password entered through the CLI. Other users, added by the
admin session, must use the correct UserName and password assigned by the admin.
As soon as at least one administrator-level user is added to the TL1 user database, the initial
TL1 "admin" user name will no longer be valid and the TL1 password entered through the CLI
will also no longer be valid. Subsequently, all users must log in using the correct user name and
password as entered in the TL1 user database.
NOTE: If you add one or more administrator level users to the TL1 user database, the
“admin” user name will be deleted at the end of the current session and the TL1 password
entered through the CLI will no longer be valid. All users must then log in using the user
names and passwords in the TL1 user database.
Normal Response to Activate User Command
When the first activate user command is accepted, the Wide Bank will respond with a normal
completion response followed by an automatic retrieve equipment response showing the
current equipment configuration:
tid 01-12-07 01:41:20
M ctag COMPLD
;
tid 01-12-07 01:41:20
A atag REPT EQPT
"DS3-A:ACTIVE,2.41.0"
"DS3-B:STANDBY,2.41.0"
"DS1-CARD-1:ACTIVE,"
"DS1-CARD-2:ACTIVE,"
"DS1-CARD-3:ACTIVE,"
"DS1-CARD-4:ACTIVE,"
"DS1-CARD-5:ACTIVE,"
"DS1-CARD-6:ACTIVE,"
"DS1-CARD-7:ACTIVE,"
"DS1-CARD-SPARE:ACTIVE,"
;