User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 9-3
TL1 Commands and Messages
TL1 Overview
General Syntax
 Command Syntax ... 9-3
 Grouping Values as Lists and Ranges ... 9-4
 Response Syntax ... 9-4
 Multiple Output Responses ... 9-5
Command Syntax
All TL1 commands have the following general format:
verb-modifier[-modifier]:[<tid>]:[<aid>]:[<ctag>]
[:[general block][:first parameter block]
...[:last parameter block]];
NOTE: The Wide Bank ships with all configuration parameters set to factory default
values unless otherwise specified. Default values appear in bold type in the tables
following the TL1 command syntax. The Wide Bank can be restored to these default
values at any time (see STA-LOCL-RST on page 9-80).
The parts of the command shown between square brackets are optional but some of these
options may be required to successfully complete specific commands.
In the Wide Bank system, the access identifier <aid>, correlation tag <ctag>, and target
identifier <tid> are optional.
If desired, you can insert the <ctag> in the command so that commands and their associated
responses can be correlated.
Field Description
verb A command action. See Command Categories on page 9-7.
modifier A modifier to limit or focus the action.
See Command Modifiers on
page 9-7
aid Access ID (optional).
See Access Identifier <aid> on
page 9-84
ctag Correlation Tag (optional).
See Correlation Tag <ctag> on
page 9-89
tid
Target ID of network element (optional).
The default value is MULTIPLEXER-1
See Target Identifier <tid> and Source Identifier <sid> on
page 9-98