User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-79
CLI Commands and Messages
CLI Command List
TEMP COPY
Name: Temporary Copy
Purpose: Save copy of current configuration in temporary storage (volatile RAM), which is not
retained if power is turned off. This command allows you to preserve a copy of the
current configuration that can be restored after making temporary changes to the
current configuration (see RESTORE on page 8-63).
Security: rw and above with basic security; admin and above with Security Upgrade
See Security on page 1-5 for an overview of basic security and the Security Upgrade
option.
Syntax: temp copy
TEST
CAUTION! THIS COMMAND WILL DISRUPT SERVICE ON THE TEST INTERFACE.
Name: Test Interface
Purpose: Perform a diagnostic self-test on an interface and display the results. Test results are
saved and can be viewed at a later time with the results command (see RESULTS on
page 8-66).
Security: rw and above
Syntax: test {all|ds3|ds1 [number|range|all]|
ds1card [n|spare]|fan[n|all]}
Field Description
all Perform all self-tests
ds1 number A low-speed DS1/E1 interface number, 1 to 28
ds1 range A range of low-speed channels separated by a hyphen as in 5-8
ds1 all All low-speed channels
ds1card n A low-speed card, 1 to 7
ds1card spare The low-speed spare card
ds3 DS3 interface (active Controller only)
fan n Fan number, A or B.
Fan power is turned on for 20 seconds. After five seconds, allowing
for the fan to spin up, the rotation speed of the fans is monitored. If
the fan is not rotating at the correct speed, an error is logged and a fan
failure alarm (Fan A, Fan B, or all) is asserted, and the Controller
Status LED blinks red.
fan all All fans