User manual

CLI Commands and Messages
CLI Command List
8-76 July 2004 Wide Bank 28 DS3 - Release 2.4
Example: status ds3
Interface Receive Transmit Loop Protection
--------- ------------ ---------- ---- ----------
DS3 C-bit Traffic Traffic None Electronics
Note: If there is a fault condition while using M23 framing, the message will also
show the status for each DS2, as in the following example.
Interface Receive Transmit Loop Protection
--------- ------------ ---------- ---- ----------
DS3 Loss of Signal RAI None Electronics
DS2 1 Loss of Framing
DS2 2 Loss of Framing
DS2 3 Loss of Framing
DS2 4 Loss of Framing
DS2 5 Loss of Framing
DS2 6 Loss of Framing
DS2 7 Loss of Framing
Example: status ds3far
Far End DS3:
Condition No Alarm
Equipment ID "WideBank28"
Facility ID "DS3 Path"
Frame ID "Frame"
Generator Number "N/A"
Location ID "DS3 Loc."
Port Number "N/A"
Unit "000000"
Example: status ethernet
Ethernet Interface:
MTU 1500
Speed 10000000
Physical Address 00-E0-97-00-29-9C
Bytes Received 0
Unicast Packets (in) 0
Non-Unicast Packets (in) 0
Discarded Packets (in) 0
Errors (in) 0
Unknown Protocols (in) 0
Bytes Transmitted 0
tcp
TCP layer statistics See example below.
udp
UDP layer statistics
Field Description