User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-75
CLI Commands and Messages
CLI Command List
Example: snmp
snmp name "DS3 28 M13 Multiplexer"
snmp location "DS3 28 Location"
snmp contact "DS3 28 Contact"
snmp getcomm "public"
snmp setcomm "public"
snmp trapcomm "public"
STATUS
Name: Status Report
Purpose: Show the status of one or more interfaces.
Security: ro and above
Syntax: status {ds1 {number|range|all}}
Syntax: status {ds3|ds3far}
Syntax: status {ethernet|icmp|ip|ppp|tcp|udp}
Syntax: status {fan [n|all]}
Field Description
ds1 number A low-speed DS1/E1 interface number, 1 to 28
ds1 range A range of low-speed channels separated by a hyphen as in 5-8
ds1 all All low-speed channels
ds3
DS3 interface
ds3far
Far-end DS3 interface. See example below.
The alarm condition code can be one of the 11 possible codes
specified in ANSI T1.107.
ethernet
Ethernet port statistics. See example below.
These statistics are also available via SNMP by referencing the
interface group defined in RFC-1213 or RFG1573. Includes:
MTU - maximum transmission unit: largest packet size, in bytes
Speed - physical line speed of connection, in bits per second.
Physical Address - Media Access Control (MAC) address
fan n Fan number, A or B. Displays status of cooling fan, including Fan
Active, Fain Fail, or Fan Not Present.
fan all All fans. Displays status of both cooling fans.
icmp
ICMP layer statistics. See example below.
ip IP interface statistics. See example below.
ppp
PPP interface statistics. See example below.