User manual

Wide Bank 28 DS3 - Release 2.4 July 2004 8-67
CLI Commands and Messages
CLI Command List
DS3 Self Test: Pass
Fan A Self Test: Fan not present
Fan B Self Test: Fan not present
REVERTIVE
Name: Revertive Mode
Purpose: Set or show the revertive switching mode. The high-speed and low-speed can be
controlled independently. When revertive ds3 is on, arm is automatically turned on (see
ARM on page 8-13).
Security: Set - rw and above
Show - ro and above
NOTE: The revertive [on|off] command is obsolete but will continue to work in
release 2.41. Please use the new revertive ds3 [on|off] command to ensure
future compatibility.
Syntax: revertive ds3 [on|off]
Syntax: revertive ds1 [on|off|reset]
revertive ls [on|off|reset]
Field Description
revertive Set high-speed or low-speed revertive switching mode.
Use the command with DS3, DS1, or LS to show current setting.
ds3 High-speed revertive mode
ds1 Low-speed revertive mode used when LSMODE is set to DS1 (see
LSMODE on
page 8-58).
Note: If three protection switches occur within a 24-hour period, the
low-speed circuit on the spare will be locked out and will not revert
back to home. Use reset option (see below) to remove the lockout.
ls Low-speed revertive mode used when LSMODE is set to DS1LS or
E1LS (see LSMODE on
page 8-58).
Note: If three protection switches occur within a 24-hour period, the
low-speed circuit on the spare will be locked out and will not revert
back to home. Use reset option (see below) to remove the lockout.
on Enable revertive switching
off Disable revertive switching
reset Reset low-speed revertive lockout. When revertive switching is on,
this command will also move the low-speed circuit back to the home
card.